02/20002-50 DocuPrint N2125RAP 58 , RAP 59Initial IssueStatus Indicator Repair Analysis ProceduresRAP 58 OCT Assy Not RecognizedProcedureSwitch the printer power off. Remove and reinstall the OCT. Switch the printer power on. Run aConfig Sheet. The OCT is listed on the Config Sheet.Y NSwitch the printer power off. Remove the Left Interface Cover (REP 1.1), Left Cover (REP1.2), and the Left Plate Assembly (REP 1.11). Remove the OCT from the printer. Switchthe printer power on. On the Print Engine Controller PWB, check the voltage between P/J35 pin 1 and frame ground. The voltage is 3.3VDC.Y NReplace the Print Engine Controller PWB (REP 9.3).Switch the printer power off. Properly install the OCT on the printer. Switch the printerpower on. On the Print Engine Controller PWB, check the voltage between P/J35 pin 1and frame ground. The voltage is 0.0VDC.Y NReplace the OCT PWB (REP 10.7).Replace the Print Engine Controller PWB (REP 9.3).Problem Solved.RAP 59 Remove Output From Offset Bin (C5)Error code indicates the output tray is full.ProcedureThere is a paper stack in the offset bin actuating the Stack Full Sensor.Y NThe paper is curled.Y NLift and release the Stack Full Actuator a few times. The actuator moves freely.Y NReplace Stack Full Actuator (REP 10.12) or Stack Full Sensor (REP 10.13), asnecessary.Enter diagnostics and select Component Test. Scroll to Sensor Input test. Manuallyactuate and deactuate the Stack Full Actuator. The number on the LCD incre-ments each time you lift and release the actuator (the count may have a shortdelay because of the sensor circuit).Y NGo to RAP 60.Replace Print Engine Controller PWB (REP 9.3).Replace paper in paper tray with fresh dry paper. Run test prints. The error code reap-pears.Y NProblem solved.Enter diagnostics and select Component Test. Scroll to Sensor Input test. Manually actu-ate and deactuate the Stack Full Actuator. The number on the LCD increments eachtime you lift and release the actuator (the count may have a short delay because ofthe sensor circuit).Y NGo to RAP 60.Replace Print Engine Controller PWB (REP 9.3).Remove the paper stack.
