02/20004-28 DocuPrint N2125REP 3.13, REP 3.14Initial IssueRepair-AdjustmentREP 3.13 Tray 1 Size PWBParts List on PL 9.1RemovalCAUTIONThese components are susceptible to electrostatic discharge. Observe all ESD procedures toavoid damage.WARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove all optional feeders.3. Remove the Left Interface Cover (REP 1.1).4. Remove Left Cover (REP 1.2).5. Remove the Front Cover Assembly (REP 1.6).6. Remove the Left Front Cover Assembly (REP 1.7).7. Remove Top Cover Assembly (REP 1.4).8. Remove the Left Plate Assembly (REP 1.11).9. Remove the Plate Handle (REP 1.12).10. Remove the Size Sensor Housing (REP 3.11).11. Remove the Size Sensor Actuators (REP 3.12)12. Remove the two screws that secure the Tray 1 Size PWB to the Size Sensor Housing (Fig-ure 1)13. Lift the PWB and disconnect P/J51 and P/J331.Figure 1 Tray 1 Size PWBReplacement1. Reinstall the components in the reverse order.REP 3.14 Size Harness AssemblyParts List on PL 9.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover (REP 1.1).3. Remove Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover Assembly (REP 1.7).6. Remove Top Cover Assembly (REP 1.4).7. Remove the Left Plate Assembly (REP 1.11).8. Remove the Plate Handle (REP 1.12).9. Remove the Size Sensor Housing (REP 3.11).10. Disconnect P/J51 from the Tray 1 Size PWB (Figure 1).11. Remove the two screws that secure the Size Harness Assembly to the Sensor (Figure 1).12. Remove the Size Harness Assembly (Figure 1).Figure 1 Size M Harness AssemblyReplacement1. Reinstall the components in the reverse order.
