02/20004-76 DocuPrint N2125REP 10.16, REP 10.17Initial IssueRepair-AdjustmentREP 10.16 Offset AssemblyParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Release the two locking tabs and remove the Offset Lever from the Offset Assembly (Fig-ure 1).9. Remove the two screws that secure the Offset Assembly to the Inner Exit Chute Assembly(Figure 1).10. Disconnect P/J229 from the Offset Catch Tray PWB (Figure 1).11. Disconnect P/J226 from the Offset Home Sensor (Figure 1).12. Remove the harness from all harness clamps.13. Remove the Offset Assembly (Figure 1).Figure 1 Offset AssemblyReplacement1. Reinstall the components in the reverse order.REP 10.17 Offset Motor AssemblyParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Remove the Offset Assembly (REP 10.16).9. Remove the two screws that secure the Offset Motor (Figure 1).10. Remove the Offset Motor Assembly (Figure 1).Figure 1 Offset Motor AssemblyReplacement1. Reinstall the components in the reverse order.
