Siemens SINUMERIK 840D Function Manual

Also see for SINUMERIK 840D sl: Manual Function manual Function manual Function manual Function manual

ProgrammingSyntax: CPOF=(FAx) CPFPOS[FAx]= Functionality: Defines the switch-off position of the following axis FAx.Value: Type: REALRange of values: All positions within the traverse range boundariesExample:Programming CommentCPOF=(X2) CPFPOS[X2]=100 ; Deactivation of coupling to following axis X2. 100is approached as switch-off position of the fol-lowing axis.Supplementary conditions● CPFPOS is only effective as switch-off position with the switch-off command CPOF.The switch command CPON evaluates CPFPOS as switch-on position (see Section"Synchronized Position of the Following Axis on Switch-on (Page 514)").● The setting of a switch-off position is only permitted with the switch-off mode:CPFMOF=STOP● Switch-off position is approached with maximum dynamics.● Block change behavior depends on parameterization of the keyword CPBC.14.5.5.11 Condition at RESET (CPMRESET)With RESET, the coupling can be activated, deactivated or the current status can be retained.The behavior can be set separately for each coupling module.ProgrammingSyntax: CPMRESET[FAx]= ""Identifiers: Coupling Mode RESETFunctionality: Defines the behavior of a coupling at RESET.Reset response: Type: STRINGRange of values:"NONE" The current state of the coupling is retained.M3: Coupled axes14.5 Generic couplingAxes and spindles520 Function Manual, 06/2019, A5E47437747B AA