Siemens SINUMERIK 840D Function Manual

Also see for SINUMERIK 840D sl: Manual Function manual Function manual Function manual Function manual

Example:Programming CommentCPLDEL[X2]=(X1) ; Deletion of leading axis X1 of the coupling to followingaxis X2.Programming with CPLA and CPDELSyntax: CPLA[FAx]= ()Designation: Coupling Lead AxisFunctionality: Deleting a leading axis/spindle: The leading axis/spindle module will bedeleted and the corresponding memory will be released. If the couplingmodule does not have a leading axis/spindle any more, the couplingmodule will be deleted and the memory will be released.Leading axis/spin‐dle:Type: AXISRange of values: All defined axis and spindle names in the channelExample:Programming CommentCPDEL=(X2) CPLA[X2]=(X1) ; Deletion of leading axis X1 of the coupling to fol-lowing axis X2.Boundary conditions● CPLDEF is only allowed in blocks without CPDEF/CPON/CPOF/CPDEL.(This limitation applies to the case where the keywords refer to the same coupling module.)● If an active leading axis is deleted, the coupling to this leading axis is implicitly deactivated.● Deletion of the last leading axis results in the entire coupling module to be deleted.14.5.4 Switching coupling on/off14.5.4.1 Switching on a coupling module (CPON)A defined coupling module is switched on with the switch command CPON.Coupling characteristics like coupling reference can be programmed together with the switchon command (see Section "Programming coupling characteristics (Page 508)").M3: Coupled axes14.5 Generic couplingAxes and spindles504 Function Manual, 06/2019, A5E47437747B AA