Programming and displayin the diameterReference axis forG96 / G961 / G962Programming: DIAM*channel-specific modalG group 29SCC[]channel-specific modalReference axis for G96/G961/G962Acceptance during axis re‐placement:DIAM*A[]axis-specific modalAxis-specific non-modal dia‐metral/radius programming:DAC, DIC; RAC, RICblockwise axis-specific only programmingDIAM*: DIAMOF, DIAMON, DIAM90, DIAMCYCOFDIAM*A[]: DIAMOFA[], DIAMONA[], DIAM90A[], DIACYCOFA[], DIAMCHANA[]: Axis name for geometry, channel or machine axis nameNoteRotary axes are not permitted to serve as transverse axes.Diameter-related dataDIAMON/DIAMONA[]After activation of the diameter programming with DIAMON/DIAMONA[] (see"Programming (Page 121)"), the following data refer to diameter dimensions:● Display data of transverse axis in the workpiece coordinate system:– Setpoint and actual position– Distance-to-go– REPOS offset● "JOG" mode:– Increment (INC) through incremental manual handwheel traversing (depending on theactive MD)● Part program programming:– End positions, independent of reference mode (G90 / G91)– Interpolation parameters of circular-path programming (G2 / G3) if these areprogrammed with part program instruction AC absolute.● Actual values read with reference to the workpiece coordinate system (WCS):– $AA_MW[]System variable of the measuring functions MEAS (measuring with delete distance-to-go)and MEAW (measuring without delete distance-to-go)– $P_EP[]– $AA_IW[]P1: Transverse axes4.1 FunctionAxes and spindles116 Function Manual, 06/2019, A5E47437747B AA PreviousNext |