The following axis-specific basic position is assigned to the transverse axis during the power-up of the NC: "Transfer of the diameter programming channel status" DIAMCHANA[]With the release of the axis-specific diameter programming (MD30460, bit 2 = 1), the followingaxis-specific operations can be used at the user's end:● DIAMONA (axis-specific modal diameter programming: ON)● DIAMOFA (axis-specific modal diameter programming: OFF)● DIAM90A (axis-specific modal diameter programming for G90 and AC, radius programmingfor G91 and IC)● DIACYCOFA (axis-specific modal diameter programming: OFF in cycles)● DIAMCHANA (transfer of the diameter programming channel status)Dimensions for tool parametersWith the following channel-specific machine data, the following tool parameters can beactivated as diameter values for all of the transverse axes defined in the channel:MD20360 $MC_TOOL_PARAMETER_DEF_MASK. = MD20360 $MC_TOOL_PARAMETER_DEF_MASKBit Value Meaning1 1 Transverse axis tool length as a diameter2 1 Alarm for wear or tool length as a diameter and plane change3 1) 0 Work offset $P_EXTFRAME and framesFor transverse axes, work offsets in frames are always calculated as radius values.1 The work offset (WO) in frames in the transverse axis as a diameterThe frame stores the work offsets internally as a radius value. There is no conversionduring a change of diameter to radius programming or vice versa.4 1 Preset value as a diameter5 1) 0 External work office (axis overlay)For transverse axes, the external work offset is always calculated as a radius value.1 External WO of the transverse axis as a diameterThere is no conversion during a change of diameter to radius programming or viceversa.6 1 Actual values of the transverse axis as a diameter7 1 Display of actual values of the transverse axis as a diameter value8 1) 1 Display of remaining path in WCS always as a radius9 1) For all of the transverse axes for which it is set that the specifications of the handwheel are pathspecifications (MD11346 $MN_HANDWH_TRUE_DISTANCE == 1), the following applies:0 Half of the path of the specified handwheel increment is traveled if channel-specific oraxis-specific diameter programming is active for this axis.1 Half of the path of the specified handwheel increment is always traveled.10 1 Tool portion of an active tool carrier that can be oriented if no tool is active11 1 Evaluation of $TC_DP6 as a diameter12 1 Evaluation of $TC_DP15 as wear of the tool diameterP1: Transverse axes4.2 ParameterizationAxes and spindlesFunction Manual, 06/2019, A5E47437747B AA 119 |
