Installing HiPath 3000 Nur für den internen GebrauchA31003-H3590-S100-7-7620, 06/20124-34 HiPath 3000/5000 V9, Service documentationinst_h3.fmInstalling HiPath 38004.1.5.3 Inserting or Removing BoardsIntroductionPeripheral boards can be inserted and removed while the power is connected. Always use theboard wrench provided for removing and inserting boards.See Section 9.1.1 for information on upgrading peripheral boards.Procedure for inserting and removing the boards7 CautionAlways wear an antistatic wristband when working on the system (especially whenhandling boards).Observe the measures for protecting electrostatically sensitive devices (seeSection 1.2.6, “Notes”).If ThenBoard is tobe re-moved.Insert the tip of the board wrench marked “Pull” into the top opening on the frontcover of the board to be removed.Lever the board out of the shelf by pushing the board wrench upwards (Figure 4-16, left).Then you can pull the module out of the system cabinet over the guide rails.Board is tobe added.Using its guide rails slide the board into the system cabinet until it stops.Insert the tip of the board wrench marked “Plug-In” into the bottom opening in thefront cover of the board.Lever the board into the shelf of the cabinet by pushing the board wrench up-wards (Figure 4-16, right).Figure 4-16 HiPath 3800 - Removing/Inserting the Board Using the Board WrenchRemoving a board Inserting a board
