Boards for HiPath 3000 Nur für den internen GebrauchA31003-H3590-S100-7-7620, 06/20123-306 HiPath 3000/5000 V9, Service documentationboards.fmPeripheral boardsSettingsTable 3-146 TMCAS-2 (for selected countries only) – Jumper FunctionsJumper Function SettingPins 1–2 closed Pins 2–3 closedX11 Sets the V.24 baud rate See Table 3-147X12X14X13 Deletes the flash mem-oryFlash memory is deleted(all sectors apart from U-boot (firmware)).Flash memory is not de-leted.(default setting)X16 Resetting the card Reset performed. Reset not performed.(default setting)X17 Hardware watchdog Watchdog active.(default setting)Watchdog not active.X24 Sets trunk impedancefor CAS interface 175 ohms(default setting)120 ohmsX25 Sets trunk impedancefor CAS interface 275 ohms(default setting)120 ohmsX999 Grounding: card / CAScableGrounding for the card isconnected to the ground-ing for the CAS cable.Grounding for the card isnot connected to thegrounding for the CAScable.(default setting)Table 3-147 TMCAS-2 (for selected countries only) – Jumper for Setting the V.24 BaudRateV.24 baud rate(Kbps)JumperX11 X12 X149.6(default setting)Open Open Open19.2 Open Open Closed38.4 Closed Open Closed57.6 Open Closed Closed115.2 Closed Closed Closed9.6 All other configurations
