Boards for HiPath 3000 Nur für den internen GebrauchA31003-H3590-S100-7-7620, 06/20123-356 HiPath 3000/5000 V9, Service documentationboards.fmOptions13 – – TA2 to SLA* a14 – – TB2 to SLA* b15 – – TA1 to SLA* a16 – – TB1 to SLA* b* = or to free analog portTable 3-174 ALUM4 - Interface Assignments (for U.S. only)Pin X3(to MDF)X4(to MDF)Y-Cable from X6 toTMGL4Y-Cable from X6 to Ana-log Ports11 To the analog station ports on the CBCC (recommended) or to four consecutive ports on an 8SLA board.Pin Assignment Pin Assignment1 R from trunk1R to station 1 1 T to TMGL4 port 1 9 T to analog port 42 T from trunk1T to station 1 2 R to TMGL4 port 1 10 R to analog port 43 R from trunk2R to station 2 3 T to TMGL4 port 2 11 T to analog port 34 T from trunk2T to station 2 4 R to TMGL4 port 2 12 R to analog port 35 R from trunk3R to station 3 5 T to TMGL4 port 3 13 T to analog port 26 T from trunk3T to station 3 6 R to TMGL4 port 3 14 R to analog port 27 R from trunk4R to station 4 7 T to TMGL4 port 4 15 T to analog port 18 T from trunk4T to station 4 8 R to TMGL4 port 4 16 R to analog port 1Note: Pinouts shown are at the board itself. The supplied main distribution frame cable (MDFcable) reverses the signal order for X3 and X4 before the MDF.Table 3-173 ALUM4 - Interface Assignments (not for U.S.)Contact Connector X3 Connector X4 Connector X6
