CHAPTER 2. MMC Programming2-294 © SAMSUNG Electronics Co., Ltd.[747] RATE CALCULATION TABLEThe RATE CALCULATION TABLE is used to define the billing charges for each COSTRATE. These rate tables correlate with the Trunk Cost Rate and the Costing Dial Plan.There are eight call costing rates. Each rate has the following data fields.No Type Description0 1ST DUR(FIRST INTERVAL DURATION)This is the amount of time at the beginning of eachcall to which a fixed cost is applied. The range is 0-999 seconds; e,g. 180 seconds (three minutes).1 1ST COST(FIRST INTERVAL COST)This is the cost for the first interval duration in £ssterling or Euros. The range is 0 to 999; e.g., 345(£3.45 or €3.45).2 2ND DUR(SECOND INTERVAL DURATION)This is the duration of each billing increment afterthe first interval has expired. The range is 0-999seconds; e.g., 006 seconds (six seconds).3 2ND COST(SECOND INTERVAL COST )This is the cost for each billing increment, in £ssterling or Euros, after the first interval has expired.The range is 0-999; e.g., 100 (£1.00 or €1.00).4 SURCHARGE This is a one-time charge, in £s sterling or Euros,that is applied to the call over and above the timecharges. The range is 0-999; e.g.,150 (£1.50 or€1.50).Currency values (£ or €)Currency values (£ or €) depend on the setting for the USE EURO optionin MMC 210.DEFAULT DATAALL COST RATES: NO DATAACTION DISPLAY1) Press Transfer button and enter 747.Display shows:COST RATE (1)1ST DUR:000 SEC2) Dial COST RATE number 1-8. (e.g., 3)ORCOST RATE (3)1ST DUR:000 SECPress Volume button to select COST RATE and pressRight Soft button to move cursor.
