OfficeServ 7000 Series Call Server Programming Manual© SAMSUNG Electronics Co., Ltd. 2-145(Continued)No Option Description6 CLIR w NUMB When this option is set to ON, CLIP numbers are transmitted to thenetwork even though CLIP Restriction is set.0. OFF1. ON8 ECT SERVICE Specifies the ISDN explicit call transfer option as follows:0. NONE1. REQ2. RCV3. BOTH(This option may not be available in certain OfficeServ system.)10 EFWD REROUT If the option is set to ON, the rerouting message can be sent asFACILITY type.11 SAME CONNID When this option is set to OFF, ISDN port is searched by CONN ID andif set to ON, searched by data channel id.13 CD PLAN Specifies the called party’s numbering plan as follows:0. UNKNOWN1. ISDN2. NATION14 CD TYPE Specifies the calling party’s number type as follows:0. UNKNOWN1. INT. NAT2. NATIONAL3. NETWORK4. SUBSCRIB5. ABBREV6. EXTEN15 TIME SYNC Determines the automatic update of the system time by the use of ISDNCalls.When this option is set to ON, the system time is updated if a correcttime value is transmitted from the trunk line.16 DIVERT In case of using MOBEX trunk, specifies partial rerouting message typeas follows:0. OFF: Rerouting message can’t be sent.1. ON: Both diverting and original called number can be sent2. EXCEPT CD: Only diverting number can be sent.17 CENTREX When ISDN trunk has centrex feature, MMC 210 ISDN PROGCON isset to OFF and the 2nd progress message is incoming, dialed digit canbe sent as ISDN message type.If the option is set to OFF, dialed digit is sent as DTMF type.
