97English7 Select [YES] with and press.Data copy to the USB memory starts.The data will be overwritten when any data exists originally.Are you OK to write the data?Data to USB MemoryYES NOThe following message is displayed after data copyhas finished.Data copy finished.8 After data copy has finished, removethe USB memory device from the USBterminal.Copying the USB memory data to thedisplay1 Insert the USB memory device, whichthe data has been copied, to the USBterminal of the display for data copy(same as the step 1 on page 96).2 After the [Select Copy Type] screen isdisplayed, go to the step 6.When the [Select Copy Type] screen is notdisplayed, follow the steps 3 to 5 to display.Note● If the USB memory containing the data for cloningis connected in power-on state, the [Select CopyType] message is displayed.3 Display [Setup] menu pressing.4 Select [OSD language] with andpress for over 3 seconds.The following display appears.OptionsDisplay serial numberShippingUSB data cloningSoftware licenses5 Select [USB data cloning] withand press .6 Select [USB Memory → Display] withand press .Select Copy TypeDisplay → USB MemoryUSB Memory → Display7 Select [YES] with and press.Data copy to the display starts.Do you copy the data?Data from USB MemoryYES NOThe following message is displayed after data copyhas finished.Cloning finished.Please turn off the power.8 After data copy has finished, removethe USB memory device from the USBterminal.9 Turn the power off by switching the ( / ) OFF ( ).The copied content is applied to the display.● Or, disconnect the AC cord plug from the walloutlet.● When USB memory is not removed in the step8, the message [Select Copy Type] is displayedwhen the display is turned on again.
