Panasonic H-55LFV60U Operating Instructions Manual

Contents

Panasonic H-55LFV60U Operating Instructions Manual Manual pdf 48 page image

English48■ [MPEG noise reduction]Reduces block noise and mosquito noise on MPEGvideos.[Off]:Disables Noise Reduction.[Min], [Mid], [Max]:Sets strength of Noise Reduction.■ [XGA mode]This menu is displayed at PC IN and COMPONENT/RGB IN inputs.This unit supports XGA signals (1024 × 768, 1280 ×768, 1366 × 768) having different aspect ratios andsampling rates.[Auto]:Automatically detects the signal.Switch the setting to suit the input signal for betterdisplay depends on the angle of view or displayresolution condition.Note● After making this setting, be sure to make eachadjustment (such as [Auto setup]) on the [Position]menu as necessary. (see page 37)■ [Signal range]This menu is displayed at HDMI1, HDMI2 and DVI-D INinputs. Switches the dynamic range to match the signalsfrom the source connected to each terminal.[Video(16-235)]:If the input signal is the video rangeExample: HDMI terminal output for DVD player[Full(0-255)]:If the input signal is full rangeExample: HDMI terminal output for personalcomputer[Auto]:Switches the dynamic range automatically between[Video(16-235)] and [Full(0-255)] according to theinput signal.Note● [Auto] can be selected when the HDMI signal input.■ [Input level]This menu is displayed at PC IN, COMPONENT/RGB INand VIDEO IN inputs.Adjustment of parts which are extremely bright and hardto see.- 16 to + 16:(Level low) - (Level high)■ [3D Y/C filter]Set this if the video looks unnatural at VIDEO IN input.Set this to [On] normally.Note● Depending on the signalling system, this settingmay be less effective or may not be effective at all.■ [Colour system]Sets the colour system according to the signal methodat VIDEO IN input. Set this to [Auto] normally. Thisautomatically detects the input signal format.[Auto], [PAL], [SECAM], [NTSC], [NTSC 4.43], [PALM], [PAL N]:Set this to [Auto] when viewing PAL-60 videos.When images are unstableWhen the system is set to [Auto], images becomeunstable in rare case under the condition that theinput signals are at low level or have many noises.In this case, set the system so it conforms with theinput signal format.■ Input signal displayDisplays the frequency and the type of the current inputsignal.60.00 Hz74.18 MHz1125(1080)/60i33.72 kHzH-freq.V-freq.Dot clock freq.Signal formatDisplay range:Horizontal (15 kHz - 135 kHz)Vertical (24 Hz - 120 Hz)The dot clock frequency is displayed when Digital andPC signal are input.