21EnglishNote● The PC IN terminal is DDC2B-compatible. If thecomputer being connected is not DDC2B-compatible,you will need to make setting changes to thecomputer at the time of connection.● There is no need to use an adapter for computerswith DOS/V compatible Mini D-sub 15P terminal.● The computer shown in the illustration is for examplepurposes only.● Additional computer, cables and conversion adaptershown are not supplied with this set.● Do not set the horizontal and vertical scanningfrequencies for PC signals which are above or belowthe specified frequency range.● Component Input is possible with the pin 1, 2, 3 of theMini D-sub 15P Connector.● Change the [Component/RGB-in select] setting inthe [Signal] menu to [Component] (when Componentsignal connection) or [RGB] (when RGB signalconnection). (see page 47)● For audio, it is also possible to use AUDIO2 INterminal input. (For [Audio input select] function, seepage 67.)Pin assignments and signal names for PC InputTerminal (Mini D-sub 15P)167839451015 14 13 12 112Pin No. Signal NameR (PR /CR )G (Y)B (PB/CB )NC (not connected)GND (Ground)GND (Ground)GND (Ground)GND (Ground)+5 V DCGND (Ground)NC (not connected)SDAHD/SYNCVDSCLVIDEO IN terminal connectionNote● Video equipment, connection cables and conversionplugs are not supplied with this unit.● For audio, it is also possible to use AUDIO1 INterminal input. (For [Audio input select] function, seepage 67.)Shared with COMPONENT/RGB IN.Stereo mini plug(M3)Video pin cable (commercially available)Pin-BNC conversion plug (commercially available)Stereo audio cable (commercially available)Video Cassette RecorderDVD Player