English20Note● Up to 10 displays can be connected with a DVI daisychain. However, the number of connectable displaysmay be limited depending on the cables, signals, thedevices used, etc.● HDCP can be supported for up to 8 displays for a DVIdaisy chain.Pin assignments and signal names for DVI-DInput/OutputPin No. Signal NameT.M.D.S. data 2-T.M.D.S. data 2+T.M.D.S. data 2 shieldDDC clockDDC dataT.M.D.S. data 1-T.M.D.S. data 1+T.M.D.S. data 1 shield+5 V DCGND (Ground)Hot plug detectT.M.D.S. data 0-T.M.D.S. data 0+T.M.D.S. data 0 shieldT.M.D.S. clock shieldT.M.D.S. clock+T.M.D.S. clock-Note● Use the supplied DVI-D cable. (Image deteriorationmay occur depending on the length or the quality ofthe cable.)● Securely tighten the screws at the both ends of theDVI-D cable.If the screws are not fixed securely, daisy chainconnection may be unstable.PC IN terminal connectionShared with DVI-D IN.Connect a cablewhich matchesthe audio outputterminal on thecomputer.(commerciallyavailable)(Female) Stereo mini plug(M3)(Male)Mini D-sub 15p cable (commercially available)Conversion adapter (if necessary) (commerciallyavailable)Stereo mini plug (M3) cable (commercially available)PCThe type of computer signal that can be connected● With regard to the typical PC input signals thatare described in “Preset Signals” (see page 93),adjustment values such as for the standard picturepositions and sizes have already been stored in thisunit.(Computer signals which can be input are those witha horizontal scanning frequency of 30 to 110 kHz andvertical scanning frequency of 48 to 120 Hz.)● The display resolution is a maximum of 1 440 × 1 080dots when the aspect mode is set to [4:3], and 1 920× 1 080 dots when the aspect mode is set to [16:9].If the display resolution exceeds these maximums, itmay not be possible to show fine detail with sufficientclarity.● In [ENGLISH(US)] OSD language, [16:9] is displayedas [FULL].