|
29EnglishBasic ControlsRemote Control Sensor /Power Indicator(Back of the unit)Main power switch ( / )(Back of the unit)AC socket outletAC cord (supplied)Operate pointing the remote control directly atthe unit’s Remote Control Sensor.Note● Do not put an obstacle between the remote controlsensor of the main unit and the remote control.● Do not subject the remote control sensor of the mainunit to the direct sunlight or strong fluorescent light.1 Connect the AC cord plug to theDisplay.(see page 15)2 Connect the plug to the socket outlet.Note● Main plug types vary between countries. The powerplug shown at left may, therefore, not be the typefitted to your set.● When disconnecting the AC cord, be absolutelysure to disconnect the AC cord plug at the socketoutlet first.● The settings may not be saved if the power plugis disconnected or the display is turned off at the immediately after changingsettings with on-screen menu. Leave enoughperiod of time before disconnecting the power plugor switching the display off at the switch>. Or, turn the power off with the remotecontrol, RS-232C control or LAN control beforedisconnecting the power plug or switching thedisplay off at the .3 Switch the ( / ) ON ( ).■ To turn the power ON/OFF with the remotecontrol or :To turn the power ONThe picture is displayed by pressing or when the isON ( ) (Power Indicator: Red or orange).● Power Indicator: Green (Picture is displayed.)To turn the power OFFThe power is turned OFF (Standby) by pressing or when the power switch> is ON ( ) (Power Indicator: Green).● Power Indicator: Red or orange (standby)When the power is ON (Picture is displayed.) or OFF(standby), the power of the display is turned OFF byswitching the OFF ( ).Note● During operation of the “Power management” function(see page 55), the power indicator turns orange in thepower off state.
PreviousNext |