|
37EnglishAdjusting Position1 Press to display the[Position] menu.0000150PositionDefault DefaultAuto setupH-positionH-sizeV-positionV-sizeClock phaseDot clock1:1 pixel mode Off2 Select the item to adjust with .● Unadjustable items are greyed out.Adjustable items differ depending on the signal,input and the display mode.3 Adjust with .4 Press to exit from adjustmode.■ To return to the previous screenPress .■ To reset to defaultsPress while the menu is displayed, orpress when [Default] is selected, then thesettings will be set to factory settings.Note● Settings for [Position] are memorised separately foreach input signal.Setting [Position] when the display is installedverticallyWhen adjusting, please note that even when thedisplay is installed vertically, setting directions ofposition / size are the same as that of horizontalinstallation.Auto setupWhen inputting a PC signal, [H-position] / [V-position],[H-size] / [V-size], [Clock phase] and [Dot clock] areautomatically corrected.This setting is enabled under the followingcondition:● When inputting from PC IN or RGB INWhile displaying the picture of the correspondingsignal, select [Auto setup] and press .Using Remote ControlPress .When Auto Setup does not work, [Invalid] isdisplayed.Auto modeWhen the [PC auto setting] is set to [On] in the [Options]menu (see page 69), automatic position adjustmentstarts under the following conditions:● When the display power is turned ON.● When the input signal is switched.Note● When the dot clock frequency of a PC signal is 162MHz or higher, [Clock phase] and [Dot clock] cannotbe automatically corrected.● Auto Setup may not work when a cropped or darkimage is input. In such case, switch to a bright imagewith borders and other objects are clearly shown,and then try auto setup again.● Depending on the signal, out of alignment mayoccur after Auto Setup. Carry out fine tuning for theposition/size as required.● If Auto Setup cannot set properly for XGA signal(1024×768, 1280×768, 1366×768), pre-selecting theindividual signal in [XGA mode] (see page 48) mayresults in correct Auto Setup.● Auto Setup does not work well when a signal suchas additional information is superimposed outof valid image period or when intervals betweensynchronizing signal and image signal are short. Alsoit does not work well for image signals with tri levelsynchronizing signal added, or for some SYNC ONG signals.● If Auto Setup does not work well, select [Default],press , and then adjust the position/sizemanually.
|
