55EnglishPower management settingsSet each item to reduce power consumption.[Power management settings] - submenu screenPower management settingsPower management modeNo signal power offHDMI1 power managementHDMI2 power managementPC power managementDVI-D power managementPower saveCustomOffOffDisableOffOffOffTo control with the remote control:Switches [Power management mode] by pressing.Power management mode On■ [Power management mode]: [On]The following fixed values are set to the menu ofpower consumption reduction. Individual setting is notavailable.[No signal power off]: [Enable][HDMI1 power management]: [On][HDMI2 power management]: [On][DVI-D power management]: [On][PC power management]: [On][Power save]: [On]■ [Power management mode]: [Custom]The menu of the power consumption reduction isindividually set. This setting is enabled when [Powermanagement mode] is set to [Custom].[No signal power off]When this is set to [Enable], the power supply of theunit goes off automatically when there is no operation orsync signal for about 10 minutes.Note● With the USB input, the unit determines no signal ispresent when the USB device is not connected.[HDMI1 power management][HDMI2 power management]When this function is set to [On], it operates underthe following conditions to turn the power on or offautomatically.When no pictures (sync signal) are detected for60 seconds or so at HDMI1 or HDMI2 input:Power is turned off (standby); the power indicatorlights up orange.When pictures (sync signal) are subsequentlydetected:Power is turned on; the power indicator lights upgreen.[DVI-D power management]When this function is set to [On], it operates underthe following conditions to turn the power on or offautomatically.When no pictures (sync signal) are detected for60 or so seconds at DVI-D input:Power is turned off (standby); the power indicatorlights up orange.When pictures (sync signal) are subsequentlydetected:Power is turned on; the power indicator lights upgreen.