2.10 Adjusting Motion Detection SensitivityIf using the motion detection feature to buffer or transfer camera images, you may want to adjust the motiondetection sensitivity for optimal results.1. Click the [Setup] tab.2. On the left side of the screen under [Buffer/Transfer], click [Motion Detection].3. Observe the [Preview] area to confirm how the current settings detect motion.• Any changes you make on this page will not be reflected in the [Preview] area until you click [Save].• You can click on the image in the [Preview] area to use the click to center feature and aim the lens inthe desired direction when confirming the current sensitivity settings.4. If necessary, adjust the detection threshold by clicking the appropriate block.5. If necessary, adjust the motion sensitivity by clicking the appropriate block.6. Click [Save], and then click [Go to Motion Detection page].7. Observe the [Preview] area to confirm how the new settings detect motion, and repeat from step 4 ifnecessary.Understanding [Threshold] and [Sensitivity]Motion detection threshold and sensitivity can be adjusted. Understanding how threshold and sensitivityinteract will help you adjust the motion detection feature to suit your needs.[Threshold]: Determines at what point the motion detection feature is triggered. A lower threshold means lessmotion is needed to trigger the motion detection feature. A higher threshold means more motion is needed totrigger the motion detection feature. Threshold is indicated in the [Preview] area by the light green area.[Sensitivity]: Determines how easily the camera detects motion. Lower sensitivity means the camera is lesslikely to detect motion. Higher sensitivity means the camera is more likely to detect motion. Motion is indicatedin the [Preview] area in dark green when it has not exceeded the detection threshold, and is indicated in darkred when it has exceeded the detection threshold.[Preview]: Refer to this area to see how the current settings (effective after clicking [Save]) detect motion.The following examples show how [Threshold] and [Sensitivity] are represented in the [Preview] area.Example 1Parameter Display Meaning[Threshold]A Low threshold (A)[Sensitivity]B Moderate sensitivity (B)[Preview]A Low threshold (A), nomotion is detected[Preview]CALow threshold (A), lowmotion (C), motiondetection is nottriggered[Preview]DALow threshold (A),moderate (D), motiondetection is triggered82 Operating Instructions2.10 Adjusting Motion Detection Sensitivity
