7.3 Specifying Operation TimesYou can specify the days and times during which general users and guest users can view camera images (theadministrator can always view camera images). When the camera is accessed outside of the operation time,the camera image on the single camera page, multi camera page, and buffered image page is displayed as agray or black screen. Additionally, [The operation time has ended.] is displayed on the single camera page.Up to 7 different operation times can be set.Note• Your privacy may be compromised if you set this feature incorrectly. To confirm that you have madethe correct settings, access the camera as a general user or guest user during a time the camera isoutside of the operational time to confirm that camera images cannot be seen.• Make sure the camera’s date and time setting is correct in order for this feature to function as desired.• If H.264 or MPEG-4 images are being viewed when the camera’s operation time ends, the last imagewill be displayed for about 20 seconds, followed by a black screen when viewing H.264 images and agray screen when viewing MPEG-4 images. If MJPEG are being viewed when the camera’s operationtime ends, the last image is displayed continuously as a still image.1. Click the [Setup] tab.2. On the left side of the screen under [Advanced], click [Operation Time].3. Select the desired operation time setting number.• If No. 1–7 are disabled, camera images can always be seen.4. Check [Enable] to enable this operating time setting number, then set the desired operation days and times.• Click [Always] to allow camera images to be seen at any time of day on the days which have a checkmark under them.5. Click [Save].166 Operating Instructions7.3 Specifying Operation Times
