Panasonic BL-C210 Series Operating Instructions Manual

Also see for BL-C210 Series: Comparison chart Specifications Installation guide Setup guide Setup guide

Contents

Panasonic BL-C210 Series Operating Instructions Manual Manual pdf 169 page image

7.5 Changing the Indicator DisplayThe POWER indicatorThe POWER indicator can be used to indicate when the camera is being accessed, however you can set thecamera so that the indicator is:– Always on (green) during normal operation– On (green) only when the camera is being accessed– On (orange) only when the camera’s built-in sensor is being triggeredThis setting is useful when deciding where to mount the camera, because the indicator will indicate whenthe built-in sensor has been triggered, allowing you to change the location of the camera to a moreappropriate location if necessary.– Always off during normal operation1. Click the [Setup] tab.2. On the left side of the screen under [Advanced], click [Indicator Control].3. Select the desired setting.4. Click [Save].Note• If the POWER indicator lights in any color other than green, refer to 1.2 POWER Indicator Issues inthe Troubleshooting Guide.The AV LINK indicator (BL-C210A/BL-C230A only)The AV LINK indicator can be used to indicate the status of the camera’s communication with a registered TV,however you can set the camera so that the indicator is:– Enabled (see The AV LINK indicator (BL-C210A/BL-C230A only) in the Troubleshooting Guide for details)– Disabled; i.e., the AV LINK indicator lights only when the camera is in registration mode1. Click the [Setup] tab.2. On the left side of the screen under [Advanced], click [Indicator Control].3. Select the desired setting.4. Click [Save].Operating Instructions 1697.5 Changing the Indicator Display