1.2.4 Registering and Changing PresetsPresets allow you to easily aim the camera lens in the desired direction. Brightness, backlight, and whitebalance settings are also saved when registering a preset. The following presets can be registered:• Home position (the direction that the lens moves to when you turn the camera on or click the centernavigator button)• Sensor position• Alarm positions 1 and 2• Presets 1–8Additionally, the first 4 presets are set by default.• 1: UpperLeft• 2: UpperRight• 3: LowerLeft• 4: LowerRightViewing a presetYou can move the lens to a preset position in the following ways:• Click the center navigator button (to move the lens to the home position)• Click [-Preset-] and select a preset from the pull-down menu• Click a blue preset button (1–8) (Unregistered preset buttons are displayed in white.)Registering or changing a presetNote• This feature is available to the camera administrator only.• Zoom settings are not registered to presets.1. Confirm that you are logged in to the camera as the administrator.2. Under [Preset] in the operation bar, click [Program].3. Aim the camera in the desired direction.4. Adjust the brightness, backlight, and white balance settings if desired. These settings will be registered tothe preset.5. Under [Preset Number], select the desired preset from the pull-down menu.6. Enter a name for the preset (max. 15 characters).• You cannot rename the home position, sensor position, or alarm positions.• See Page 206 for a list of valid characters. Note that [Space], ["], ['], [&], [<] and [>] cannot be used.7. Click [Save] to register the preset, or click [Back] to cancel.• When [Success!] is displayed, click [Back] to continue.Deleting a presetNote• This feature is available to the camera administrator only.1. Confirm that you are logged in to the camera as the administrator.2. Under [Preset] in the operation bar, click [Program].3. Under [Preset Number], select the desired preset from the pull-down menu.• You cannot delete the home position or alarm positions.4. Click [Delete] to delete the preset, or click [Back] to cancel.• When [Success!] is displayed, click [Back] to continue.Operating Instructions 291.2.4 Registering and Changing Presets
