h. Under [Transfer Method], select the desired transfer method.– [No Transfer, No Memory Overwrite]: Images are not transferred. Images are buffered until thememory is full.– [No Transfer, Memory Overwrite]: Images are not transferred. Once the memory is full, new imagesreplace the old images.– [FTP]: After the camera is triggered, it transfers images to the specified FTP site.– [E-mail]: After the camera is triggered, it sends images to the specified E-mail address.– [HTTP]: After the camera is triggered, it transfers images to the specified website.i. Under [Send Notification When Triggered], select the desired method for receiving notification whenthe camera is triggered, or select [Disable].7. Follow the procedure below based on the settings you made under [Transfer Method] and [SendNotification When Triggered].a. If you selected to not transfer images and to not send notification when the camera is triggered, click[Save] to finish.• All images buffered in the internal memory for the selected trigger are deleted when you click[Save].b. If you selected to transfer images by FTP, E-mail, or HTTP, click [Next].• The appropriate transfer settings page is displayed.– For FTP transfer, see Page 61.– For E-mail transfer, see Page 63.– For HTTP transfer, see Page 66.c. If you selected to not transfer images, but selected to send notification, click [Next].• The appropriate notification settings page is displayed.– For E-mail notification, see Page 69.– For HTTP notification, see Page 72.Note• Screen content varies by model number.• In order for this feature to work as expected, make sure the camera’s date and time setting is correct(see Page 140).• When selecting the buffer or transfer rate, keep in mind that the actual rate may be slower dependingon network conditions, the number of people accessing the camera, and the type of objects beingviewed.58 Operating Instructions2.2 Configuring a Sensor, Alarm, or Detection Trigger
