BOP HIPWR 031912 3-25FIGURE 3-8. SAVED SETUPS MENU2. Use the U and Y keys to highlight the desired memory location; To erase a highlightedmemory location, press #. The list will show erased locations as Empty.3. Press ! to see the details stored in the highlighted location.4. Once the details are displayed, use the U and Y keys to highlight the desired parameter.NOTE: If a value to be saved is beyond the range of the unit, the value saved will be limited tothe maximum value. If the Mode is changed, the numerical values for the main andprotection channels must be revised accordingly.• To modify the parameter, press !. Highlight the desired choice from a list, or use thekeypad to enter a numeric value, then press $ to save, or % to abort.• To exit without changing the parameter, press %.5. Continue to modify parameters as described in step 4 above. When all parameters havebeen modified, press $ to save for power-up. Press % to exit without storing thechanges.NOTE: If the message CHANGES NOT ALLOWED is displayed, the memory location has beenremotely locked (see PAR. A.12 for details).6. After the changes have been saved, the unit returns to the Saved Settings screen, wherethe saved settings can now be applied to the output by pressing @.3.3.8.4 COPYING PREVIOUSLY SAVED SETTINGS TO A NEW LOCATION1. Press ! from the power-up screen to enter the Saved Setups screen (Figure 3-8).2. Use the U and Y keys to highlight the location to be copied, then press $.VOLTAGESOURCEVOLTAGE CURRENT0.0000 0.0000
