228-1352 SAFETY - (COVER REMOVAL) 031912 CSAFETY INSTRUCTIONS1. Installation, Operation and Service PrecautionsThis product is designed for use in accordance with EN 61010-1 and UL 3101 for Installation Category 2,Pollution Degree 2. Hazardous voltages are present within this product during normal operation. The prod-uct should never be operated with the cover removed unless equivalent protection of the operator fromaccidental contact with hazardous internal voltages is provided:2. GroundingThis product is a Class 1 device which utilizes protective earthing to ensure operator safety.3. Electric Shock HazardsThis product outputs hazardous voltage and energy levels as a function of normal operation. Operatorsmust be trained in its use and exercise caution as well as common sense during use to prevent accidentalshock.There are no operator serviceable parts or adjustments within the product enclosure.Refer all servicing to trained service technician.Source power must be removed from the product prior to performing any servicing.This product is factory-wired for the nominal a-c mains voltage indicated on the rat-ing nameplate located adjacent to the source power connection on the product's rearpanel. To reconfigure the product input for other nominal mains voltages as listedherein, the product must be modified by a trained service technician.The PROTECTIVE EARTHING CONDUCTOR TERMINAL must be properly con-nected prior to application of source power to the product (see instructions on instal-lation herein) in order to ensure safety from electric shock.PROTECTIVE EARTHING CONDUCTOR TERMINAL - This symbol indicates thepoint on the product to which the protective earthing conductor must be attached.EARTH (GROUND) TERMINAL - This symbol is used to indicate a point which isconnected to the PROTECTIVE EARTHING TERMINAL. The component installer/assembler must ensure that this point is connected to the PROTECTIVE EARTH-ING TERMINAL.CHASSIS TERMINAL -This symbol indicates frame (chassis) connection, which issupplied as a point of convenience for performance purposes (see instructions ongrounding herein). This is not to be confused with the protective earthing point, andmay not be used in place of it.This symbol appears adjacent to any external terminals at which hazardous voltagelevels as high as 500V d-c may exist in the course of normal or single fault condi-tions.This symbol appears adjacent to any external terminals at which hazardous voltagelevels in excess of 500V d-c may exist in the course of normal or single fault condi-tions.!!!!!
