Connecting to an External Monitor109NOTES• When q > [Output Terminal] is set to [ HD/SD-SDI & HDMI], the signal outputfrom the HDMI OUT terminal will be determined by the q > [HD/SD-SDI Output] setting.• The HDMI OUT terminal on the camcorder is for output only. Do not connect it to an HDMI outputterminal on an external device, as this may damage the camcorder.• There will be no video output from the AV OUT terminal while an external monitor is connected tothe HDMI OUT terminal.• Correct operation cannot be guaranteed when connecting the camcorder to DVI monitors.• Video may not be output correctly depending on the monitor. In such case, use another terminal.• If you selected an option other than [k Automatic] and the connected monitor is not compatiblewith the signal output from the camcorder, then HDMI output will stop.• By default, onscreen displays will be embedded in the output video signal. You can change thisusing the q > [Output Onscreen Displays] setting.Using the AV OUT TerminalThe AV OUT terminal outputs a down-converted analog video signal and audio signal for connectionto monitors with a composite audio/video input.NOTES• When you play back a scene on a monitor with a 4:3 aspect ratio, the monitor will switchautomatically to widescreen mode if it is compatible with the Video ID-1 system.• If you are connecting the camcorder to a standard definition monitor without widescreen mode,make sure to change the s > [TV Type] setting.COPY
