Connecting to an External Monitor108Selecting the Terminal Used For OutputTo output your recordings on an external monitor, you must first select which terminal you will use.1 Open the [Output Terminal] screen.[FUNC.] > [MENU] > q > [Output Terminal]• Touching [FUNC.] is necessary only when performing the procedure in mode.2 Touch the desired option and then touch [X].• If you selected [ HD/SD-SDI], [ HD/SD-SDI & HDMI] or [ HDMI], continue with therelevant procedure below to configure the output signal.OptionsUsing the HD/SD-SDI TerminalThe digital signal output from the HD/SD-SDI terminal includes the video signal, audio signal and timecode signal. If necessary, perform the following procedure to change the output to HD or SD.1 Open the [HD/SD-SDI Output] screen.[FUNC.] > [MENU] > q > [HD/SD-SDI Output]• Touching [FUNC.] is necessary only when performing the procedure in mode.2 Touch the desired option and then touch [X].NOTES• By default, onscreen displays will be embedded in the output video signal. You can change thisusing the q > [Output Onscreen Displays] setting.Using the HDMI OUT TerminalThe HDMI TM OUT terminal also offers a digital connection and outputs both a video and audio signal.If you selected [k Automatic], the output signal will automatically switch to HD or SD depending onthe capability of the external monitor. In mode, when the recording mode is set to 28 MbpsLPCM (59.94P) or 24 Mbps LPCM, the HDMI OUT terminal outputs two-channel linear PCM audiowith a sampling frequency of 48 kHz.1 Open the [HDMI Output] screen.[FUNC.] > [MENU] > q > [HDMI Output]• Touching [FUNC.] is necessary only when performing the procedure in mode.2 Touch the desired option and then touch [X].[j Off] There is no output from any terminal.[ HD/SD-SDI] There is output only from the HD/SD-SDI terminal.[ HD/SD-SDI & HDMI] There is output from the HD/SD-SDI and HDMI OUT terminals.[ HDMI] There is output only from the HDMI OUT terminal.[Ò AV OUT] There is output only from the AV OUT terminal.COPY
