11 Appendix11.2.2 Parameters11-28∗1. Normally set to "0." When using an external regenerative resistor, set the capacity (W) of the regenerative resistor.∗2. The upper limit is the maximum output capacity (W) of the SERVOPACK.Pn52B Overload Warning Level 1 to 100 1% 20 Immediately Setup 5.2.8Pn52C Derating of Base Current at DetectingOverload of Motor 10 to 100 1% 100 After restart Setup 5.2.8Pn52F Monitor Display at Power ON 0000 to 0FFF − 0FFF Immediately Setup 8.7Pn530Program JOG Operation RelatedSwitch 0000 to 0005 − 0000 Immediately Setup 7.5Pn531 Program JOG Movement Distance1 to1073741824(230)refer-ence unit 32768 Immediately Setup7.5Pn533 Program JOG Movement Speed 1 to 10000 1 min -1 500 Immediately SetupPn534 Program JOG Acceleration/Decelera-tion Time 2 to 10000 1 ms 100 Immediately SetupPn535 Program JOG Waiting Time 0 to 10000 1 ms 100 Immediately SetupPn536 Number of Times of Program JOGMovement 0 to 1000 1 time 1 Immediately SetupPn550 Analog Monitor 1 Offset Voltage -10000 to10000 0.1 V 0 Immediately Setup6.1.3Pn551 Analog Monitor 2 Offset Voltage -10000 to10000 0.1 V 0 Immediately SetupPn552 Analog Monitor Magnification (×1) -10000 to10000 ×0.01 100 Immediately SetupPn553 Analog Monitor Magnification (×2) -10000 to10000 ×0.01 100 Immediately SetupPn560 Remained Vibration Detection Width 1 to 3000 0.1% 400 Immediately Setup 6.7.1Pn561 Overshoot Detection Level 0 to 100 1% 100 Immediately Setup 6.3.16.4.1Pn600 Regenerative Resistor Capacity ∗1Depends onSERVOPACKCapacity ∗210 W 0 Immediately Setup 3.6.1Pn601 Reserved (Do not change.) – – 0 – – –ParameterNo. Name SettingRange Units FactorySettingWhenEnabled Classification ReferenceSection4thdigit 3rddigit 2nddigit 1stdigitn.Program JOG Operation Related Switch012345Reserved (Do not change.)(Waiting time Pn535 → Forward movement Pn531) × Number of times of movement Pn536(Waiting time Pn535 → Reverse movement Pn531) × Number of times of movements Pn536(Waiting time Pn535 → Forward movement Pn531) × Number of times of movements Pn536(Waiting time Pn535 → Reverse movement Pn531) × Number of times of movements Pn536(Waiting time Pn535 → Reverse movement Pn531) × Number of times of movements Pn536(Waiting time Pn535 → Forward movement Pn531) × Number of times of movements Pn536(Waiting time Pn535 → Forward movement Pn531 → Waiting time Pn535 →Reverse movement Pn531) × Number of times of movement Pn536(Waiting time Pn535 → Reverse movement Pn531 → Waiting time Pn535 →Forward movement Pn531) × Number of times of movement Pn536Reserved (Do not change.)Reserved (Do not change.)
