11 Setups178 Xerox Phaser 3635 User GuideA different time period may be specified for documents received in mailboxes andfor documents stored for polling (whether in general memory or a private mailbox).Choose the appropriate option and select whether to Delete on Print or Keep.Mailbox SetupTools > User Interface > Fax Service Settings > Mailbox SetupThe Mailbox Setup feature allows the System Administrator to edit the mailbox id,passcode and name. The System Administrator can also enable or disable theMailbox Notification feature that sets whether a user receives fax notification ornot.Line ConfigurationThe fax option supports one analogue telephone line. This feature enables theSystem Administrator to configure the fax lines for PSTN (Public SwitchingTelephone Network) systems. Set the dial type of the line to either Tone or Pulse.Enter the Fax Number and Machine Name (a friendly or easy-to-remember faxname).Tools > User Interface > Fax Service Settings > Line ConfigurationFax ReportThis facility allows you to enable the Always Print and Print on Error features forthe reports below. An Auto-Print feature can be used for the Transmission/Receive Report.Tools > User Interface > Fax Service Settings > Fax Report• Transmission/Receive Report: Reports details on recently transmitted orreceived faxes.• Confirmation Report: Reports transmission status and can be printed afterevery transmission or only when a transmission error occurs.• Broadcast Report: Reports the success or failure of a fax sent to severaldestinations and can be printed after every transmission or only when atransmission error occurs.• Multipoll Report: Reports the success or failure of a polled fax to severaldestinations and can be printed after every transmission or only when atransmission error occurs.Error Correction ModeThis mode compensates for poor line quality and ensures accurate, error-freetransmission with any other Error Correction Mode equipped fax machine.However, if the line quality is poor, the transmission time may be increased whenthis mode is enabled.Tools > User Interface > Fax Service Settings > Error Correction Mode
