Toshiba 24SLV411U Owner's Manual

Also see for 24SLV411U: Owner's manual Owner's manual Specifications Energy guide

To tune to a channel or input in Select mode:. . BACK NX1Whde watching TV, press _ '_ or _ t_ to open tileChannel Browser *_and surf back to a previous itemo1"t_rward to the next item in the list.In Select mode, when you stop on an item in theChannel Browser'", it will be highlighted but youmust press @ to tune the TV to the highlighteditem,2 Press o_ to tune the TV to the highlighted item.3 Press c_E to close the Channel Browse€ ".gddino and cleadng channels and inputsin the History ListAdding channels and inputs to the HistoryList:As a channel or input is tuned, the Channel Browser ''*adds it to the History List and displays it on the "rightside" of the Channel Browser "*.Previously tunedchannels/inputs are "shifted" to the left, eventuallymoving off the left side. Press _ "_lto surf backwardthrough the previously tuned channels/inputs. Anychannel or input that is tuned repeatedly will not berepeated in the History List, but instead is moved tothe end of the list on the right side of the ChannelBrowser s``"The Channel Browser TM will store the followingchannels:,, All channels that are tuned using the numeric buttonson the remote control.,, All channels that are tuned using [_ or _ on theremote control.Note: Whenever an item is selected that cannotbe tuned (for various reasons), the TV willautomatically tune to the previously viewedchannel or input.Clearing channels from the History List:• Reconfiguring the ANT/CABLE input will clear theHistory List.Note: See page 26 for details on configuringthe antenna input.,, Turning off the TV will clear the History List.Setting the ChannelTuningNodeThis feature allows you to choose how tuning will behandled for analog and digital channels when the TVis in Antenna mode.Note: To use this feature, the Input Configurationmust be set to Antenna (_. page 26).The channel tuning mode has three options.Standard Both analog and digital channels canbe tuned normallyDigital channels will have priority whenmanually entering a channel numberAuto using the Channel Number (0-9) on the(default) remote control, analog channels canstill be tuned by [7_] / 1_1, if availableDigital Only digital channels can be tunedNote: Digital mode will be most useful afteranalog channels were shut down by thegovernment in 2009.To set the Channel Tuning Mode:1 From the Setnp menu, highlight Installation andpress @. A new set of Installation menu iconswill appear.Open the Terrestrialmenu, highlight ChannelTuning Node, and then press "_ or _ to selectyour desired mode.No te:° The Channel Options windows as well asthe Channel Browser ANT/CABLE list will beupdated automatically when you change themode. Also, the History List will be cleared, butthe Favorites List will be saved.° Even if the Channel Tuning Mode is set toDigital, analog channel 3 will still be thedefault channel to prevent the initial casewhere no digital channels have been found inprior channel scans. (Channel Options will nothave anything listed until a scan is done.)