Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

3. Press the menu forward key and the "Settings" softkey.4. Press the "Measurement log" softkey.The "Settings for measurement log" window is opened.5. Position the cursor to the log format field and select the required entry.6. Position the cursor to the log data field and select the required entry.7. Position the cursor to the log archive field and press the softkey "Selectdirectory".8. Navigate to the desired directory for the log archive.9. Press the "OK" softkey and enter the name for the log file.See alsoLogging tool measurement results (Page 83)Logging measurement results for the workpiece zero (Page 86)4.8 Zero offsetsFollowing reference point approach, the actual value display for the axis coordinates is basedon the machine zero (M) of the machine coordinate system (Machine). The program formachining the workpiece, however, is based on the workpiece zero (W) of the workpiececoordinate system (Work). The machine zero and workpiece zero are not necessarily identical.The distance between the machine zero and the workpiece zero depends on the workpiecetype and how it is clamped. This zero offset is taken into account during execution of theprogram and can be a combination of different offsets.Following reference point approach, the actual value display for the axis coordinates is basedon the machine zero of the machine coordinate system (Machine).The actual value display of the positions can also refer to the SZS coordinate system (settablezero system). The position of the active tool relative to the workpiece zero is displayed.Setting up the machine4.8 Zero offsetsTurning88 Operating Manual, 05/2017, A5E40868721