Parameter "Longitudinal thread" in the "Input complete" modeG-code program parameters Parameters, ShopTurn programInput ● CompletePL Machining plane T Tool nameD Cutting edge numberS / V Spindle speed or constant cuttingraterpmm/minParameter Description UnitTable Thread table selection:● Without● ISO metric● Whitworth BSW● Whitworth BSP● UNCSelection - (not for table"Without")Data, table value, e.g. M10, M12, M14, ...P Select the thread pitch / turns for table "Without" or specify the thread pitch/turnscorresponding to the selection in the thread table:● Thread pitch in mm/revolution● Thread pitch in inch/revolution● Thread turns per inch● Thread pitch in MODULUSmm/revin/revturns/"MODULUSG Change in thread pitch per revolution - (only for P = mm/rev or in/rev)G = 0: The thread pitch P does not change.G > 0: The thread pitch P increases by the value G per revolution.G < 0: The thread pitch P decreases by the value G per revolution.If the start and end pitch of the thread are known, the pitch change to be programmedcan be calculated as follows:|Pe2 - P2 |G = ----------------- [mm/rev2]2 * Z1The meanings are as follows:Pe: End pitch of thread [mm/rev]Pa: Start pitch of thread [mm/rev]Z1: Thread length [mm]A larger pitch results in a larger distance between the thread turns on the workpiece.mm/rev2Machining ● ∇ (roughing)● ∇∇∇ (finishing)● ∇ + ∇∇∇ (roughing and finishing)Programming technology functions (cycles)10.2 RotateTurning362 Operating Manual, 05/2017, A5E40868721