Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

6. In the lefthand input field of the Spindle parameter, select main spindle,tool spindle or counterspindle.7. Enter the spindle speed or cutting rate.8. In the selection box "Plane selection", select between the machiningplanes.9. Enter the cylinder diameter if you selected the machining plane peripheralsurface C.- OR -Enter the positioning angle for the CP machining area if you selectedmachining plane face Y.- OR -Enter reference point C0 if you selected the machining plane peripheralsurface Y.- OR -Choose whether the spindle should be clamped or released or whetherthere should be no change (input field left blank).Press the "Accept" softkey.The values are saved and the window is closed. The process plan is dis‐played and the newly generated program block is marked.Parameter Description UnitT Tool nameD Cutting edge numberS1 / V1 Spindle speed orconstant cutting raterpmm/minPlane selection Select between the following machining surfaces:● Peripheral surface/Peripheral C● Peripheral surface Y - only if there is a Y axis● Face/Face C● Face Y - only if there is a Y axis● Turning∅ Diameter of the cylinder (for peripheral surface/peripheral C) mmC0 Positioning angle for machining area (for peripheral surface Y) DegreesCP Positioning angle for machining area (for face Y)Angle CP does not have any effect on the machining position in relation to the work‐piece. It is only used to position the workpiece with the rotary axis C in such a waythat machining is possible on the machine.Degrees10.7.11 Programming a straight lineWhen you want to program a straight line in right-angled coordinates, you can use the "Straight"function.The tool moves along a straight line at the programmed feedrate or at rapid traverse from itsactual position to the programmed end position.Programming technology functions (cycles)10.7 Additional cycles and functions in ShopTurnTurningOperating Manual, 05/2017, A5E40868721 575