Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

ViewsThe following views are available for all three variants:● Side view● Half section● Front view● 3D view● 2-windowStatus displayThe current axis coordinates, the override, the current tool with cutting edge, the currentprogram block, the feedrate and the machining time are displayed.In all views, a clock is displayed during graphical processing. The machining time is displayedin hours, minutes and seconds. It is approximately equal to the time that the program requiresfor processing including the tool change.Software optionsYou require the "3D simulation of the finished part" option for the 3D view.You require the "Simultaneous recording (real-time simulation)" option for the"Simultaneous recording" function.Determining the program runtimeThe program runtime is determined when executing the simulation. The program runtime istemporarily displayed in the editor at the end of the program.Properties of simultaneous recording and simulationTraversing pathsFor the simulation, the displayed traversing paths are saved in a ring buffer. If this buffer isfull, then the oldest traversing path is deleted with each new traversing path.Optimum displayIf simultaneous machining is stopped or has been completed, then the display is againconverted into a high-resolution screen. In some cases this is not possible. In this case, thefollowing message is output: "High-resolution image cannot be generated".Working zone limitationNo working zone limits and software limit switches are effective in the tool simulation.Start position for simulation and simultaneous recordingDuring simulation, the start position is converted via the zero offset to the workpiece coordinatesystem.The simultaneous recording starts at the position at which the machine is currently located.Simulating machining7.1 OverviewTurning198 Operating Manual, 05/2017, A5E40868721