Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Parameter Description UnitMachiningposition● Single positionMill rectangular pocket at the programmed position (X0, Y0, Z0).● Position patternPosition with MCALLX0Y0Z0(only for G code)The positions refer to the reference point:Reference point X – (only for single position)Reference point Y – (only for single position)Reference point ZmmmmmmX0 or L0Y0 or C0Z0(only for Shop‐Turn)Face C: The positions refer to the reference point:Reference point X or reference point length polar – (only for single position)Reference point Y or reference point angle polar – (only for single position)Reference point Z – (only for single position)mmmm or de‐greesmmCPX0 or L0Y0 or C0Z0(only for Shop‐Turn)Face Y: The positions refer to the reference point:Positioning angle for machining area – (only single position)Angle CP does not have any effect on the machining position in relation to the workpiece.It is only used to position the workpiece with the rotary axis C in such a way that machiningis possible on the machine.Reference point X or reference point length polar – (only for single position)Reference point Y or reference point angle polar - (only for single position)Reference point Z - (only for single position)Degreesmmmm or de‐greesmmY0 or C0Z0X0(only for Shop‐Turn)Peripheral surface C: The positions refer to the reference point:Reference point Y or reference point angle polar - (only for single position)Reference point Z - (only for single position)Cylinder diameter ∅ – (only for single position)mm or de‐greesmmmmC0Y0Z0X0(only for Shop‐Turn)Peripheral surface Y: The positions refer to the reference point:Positioning angle for machining surface – (only for single position)Reference point Y – (only for single position)Reference point Z – (only for single position)Reference point X – (only for single position)DegreesmmmmmmW Slot width mmL Slot length mmα0 Angle of rotation of slotFace: α0 refers to the X axis or to the position of C0 for a polar reference pointPeripheral surface: α0 refers to the Y axisDegreesZ1 Slot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇) mmProgramming technology functions (cycles)10.4 MillingTurningOperating Manual, 05/2017, A5E40868721 469