Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

the tool length or radius compensation. This ensures a consistent level of accuracy duringworkpiece machining.Monitoring typesYou can automatically monitor the tools' working times via the workpiece count, tool life orwear.NoteCombination of monitoring typesYou have the option to monitor a tool by a type or any combination of monitoring types can beswitched on.In addition, you can disable tools when you no longer wish to use them.Tool parametersColumn heading MeaningLocationBS* If activated in magazineselectionMagazine/location number● The magazine location numbersThe magazine number is specified first, followed by the location numberin the magazine.If there is only one magazine, only the location number is displayed.● Load position in the load magazineThe following icons can also be displayed for other magazine types (e.g.for a chain):● Spindle location as an icon● Locations for gripper 1 and gripper 2 (applies only when a spindle withdual gripper is used) as iconsType Tool typeDepending on the tool type (represented by an icon), certain tool offsetdata is enabled.The icon identifies the position of the tool; this was selected when the toolwas created.You have the option of changing the tool position or the tool type using the/ 894

Related manuals for Siemens SINUMERIK 828D Turning