Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

When you are loading a tool, the application automatically suggests an empty location. Youmay also directly specify an empty magazine location.You can unload tools from the magazine that you are not using at present. HMI thenautomatically saves the tool data in the tool list in the NC memory outside the magazine.Should you want to use the tool again later, simply load the tool with the tool data into thecorresponding magazine location again. Then the same tool data does not have to be enteredmore than once.Procedure1. The tool list is opened.2. Place the cursor on the tool that you want to load into the magazine (ifthe tools are sorted according to magazine location number you will findit at the end of the tool list).3. Press the "Load" softkey.The "Load to… " window opens.The "... location" field is pre-assigned with the number of the first emptymagazine location.4. Press the "OK" softkey to load the tool into the suggested location.- OR -Enter the location number you require and press the "OK" softkey.- OR -Press the "Spindle" softkey.. The tool is loaded into the specified magazine location or spindle.Several magazinesIf you have configured several magazines, the "Load to ..." window appears after pressing the"Load" softkey.If you do not want to use the suggested empty location, then enter your desired magazine andmagazine location. Confirm your selection with "OK".Multiple load pointsIf you have configured several loading points for a magazine, then the "Load Point Selection"window appears after pressing the "Load" softkey.Select the required loading point and confirm with "OK".Tool management13.5 Tool listTurning668 Operating Manual, 05/2017, A5E40868721