Samsung DCS Programming Manual

Also see for DCS: User guide Quick reference guide User guide Guide Technical manual

Contents

DCS MMC PROGRAMSCOMBINED PROGRAMMING MANUAL NOVEMBER 2001MMC 508 (Page 1 of 1)MMC: 508 CALL COSTDCS 33 CI 33 CII 33 816 33 408i 33 408 33Allows the system administrator to set the Call Cost attributes generated by the system during acall. This information can be displayed on the keyphone LCD during a call or as an SMDR re-cord.Attributes are as follows:0 UNIT COST PER MP When the system is installed to receive MP on a C.O. outgoing call. Itis used for generating total call cost by multiplying it by the numberof pulses. Allows a maximum value of 5000.1 CALL COST RATE This generates additional call cost calculated by multiplying this rateby the original call cost. Ranges from 100 to 255.WARNING• Changing a value when there is a call in progress may result in an inaccurate call cost.• This MPD facility requires the Meter Pulse Detection version of the trunk card. It is not avail-able on the standard product.PROGRAM KEYSUP & DOWN Used to scroll through optionsKEYPAD Used to enter selectionsSOFT KEYS Move cursor left and rightSPEAKER Used to store data and advance to next MMCACTION DISPLAY1. Open programming and select 508Display showsUNIT COST PER MP0200PENCE→2. Dial 0 or 1 (e.g. 1)ORPress UP or DOWN key for selection and press RIGHTsoft key to move cursorCALL COST RATE100% →_3. Enter new value (e.g. 110 for 110 percent)System returns to step 2 CALL COST RATE110% →4. Press TRSF to store and exitORPress SPEAKER to store and advance to next MMCDefault Data: UNIT COST PER MP 200 penceCALL COST RATE 100 percentRelated Items: MMC 110 Station On/OffMMC 414 MPD/PRS Signal