Copying_ 74Setting job completion notificationWhen a copy job is completed, this machine can send the completionnotification using an email. This feature is helpful for a large copy job. Youdo not need to wait beside the machine until the copy job is completed .To recieve the job completion notification, you need to set up networkparameters and email settings using the control panel or SyncThru™Web Service. For details about how to set up the network parametersand email settings, refer to the Administrator’s Guide on the suppliedCD.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Set the copy features in the Advanced or Image tabs, if necessary (see"Using special copy features" on page 61).5. Enter the number of copies using the numeric keypad on the controlpanel, if necessary.6. Press the Advanced tab > Job Completion Notification.7. Press On to activate this feature.8. Press Email Address input area. The pop-up keyboard appears.Enter the email address which you want to recieve the job completionnotification. Press OK. You can also• You can select the email address pressing Address Book.• You can enter an email address only.9. Press OK from the display screen.10. Press Start on the control panel to begin copying.Build jobThis feature allows you to copy various originals at once consisting ofmultiple batches and/or different sizes. The copy job will start after scanningall originals.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Set the copy features in the Advanced or Image tabs, if necessary (see"Using special copy features" on page 61).5. Press the Advanced tab > Build Job from the display screen.6. Press On. The machine starts to scanning.After the scanning, the machine shows the window asking to placeanother page. Load another original and press Yes. You can change thecopy setting pressing Change Settings, if necessary. When you finish,select No on this window.7. The machine starts to print out.Selecting the type of originalsThe original type setting is used to improve copy quality by selectingdocument types for current copy jobs.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).
