Copying_ 71WatermarkThe watermark option allows you to print text over an existing document.For example, you use it when you want to have large gray letters reading“DRAFT” or “CONFIDENTIAL” printed diagonally across the first page or allpages of a document.This feature may not be available depending on models or option kitsinstalled.There are several predefined watermarks that come with the machine. Youcan also enter a watermark you want.When you use this option, Booklet in the Advanced tab isinactivated.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Press the Advanced tab > Watermark from the display screen.5. Press the appropriate option.• Off: Disables this feature.• Other preset values: Allows you to easily select values commonlyused.• Custom: Allows you to enter a text message using the pop-upkeyboard.6. Set the Watermark settings.• Pages: Select to print the option on all pages or only the first page.• Text Color/Size: Select the text message color and size.• Position: Select the printed position of the text message.7. Press OK from the display screen.8. Press Start on the control panel to begin copying.OverlayAn overlay is text and/or images stored on the hard drive as a special fileformat that can be printed on any document. You can store scanned formson the hard drive as an overlay to apply to copy output.When you use this option, Booklet and Poster in the Advanced tab isinactivated.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Press the Advanced tab > Overlay > On from the display screen.5. Press the appropriate option.If the Overlay feature is set with the On-Force mode fromMachine Setup > Application Settings > Copy Settings >Overlay by your administrator, you cannot set and change alloverlay options. The overlay option the administrator set is applied
