Copying_ 61Using special copy featuresOn the Advanced or Image tab of the Copy screen, you can select specificcopy features.Selecting the size of originalsCopies can be produced after specifying the document scanning size if thedocument size cannot be detected automatically or if you wish to specify acertain document size.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Press Advanced tab > Original Size from the display screen.5. Select the original size.You can change the paper list on the display screen pressing InchSize or mm Size. The paper list is divided into the available A/Bsize type and letter size type paper in this machine.• Custom: If there is no required size paper or you need to usecustom sized paper, press the cardinal point arrows to set theoriginal size. You can also set and save the custom size usingCustom Size. You can select the custom size whenever you need it.The custom size is different depending on where the originalsare placed.• Auto: Automatically detects the size of originals, but this option issupported only when originals are Letter, Ledger, Legal, Statement,A3, A4, A5, B4, or JIS B5-sized.• Mixed Size: Allows the use of both of Letter and Legal-sized paperstogether, and the machine uses the proper-sized paper from severaltrays. For example, if the originals total 3 pages, the 1st page isletter-sized paper, the 2nd page is legal-sized paper, and the 3rdpage is letter-sized paper, then the machine prints the output firstletter, legal, and letter in order from several trays.Mixed Size is activated when the originals are placed in theDADF.• Other preset values: You can select the size of original directly bypressing the buttons.6. Press OK from the display screen.7. Press Start on the control panel to begin copying.Selecting the orientation of originalsWhen copying double-sided documents or making double-sided copies orcombined copies, specify the document orientation; otherwise, the copiesmay not be printed in the correct page order or correct front and back pagearrangement.1. Press Copy from the display screen.2. Place the originals face up in the DADF or place a single original facedown on the scanner glass and close the DADF (see "Loading originals"on page 35).3. Adjust the settings for each copy such as Paper Supply,Reduce/Enlarge, Duplex and more in the Basic tab (see "Changing thesettings for each copy" on page 54).4. Press Advanced tab > Original Orientation from the display screen.5. Select the orientation of the original document.• Upright Images: Select this setting for an original document loadedwith the top toward the back of the machine.In the DADF On the scanner glassMinimum size 128 x 128 mm(5 x 5 inches)25 x 25 mm(1.0 x 1.0 inches)Maximum size 297 x 432 mm(11.7 x 17.0 inches)297 x 432 mm(11.7 x 17.0 inches)
