-36-Notes:• When the panning or tilting in the AUTO PANmode is controlled manually, the Auto modefunction should be cancelled.To activate the auto mode, select the AUTOPAN mode again or set a time for SELFRETURN in the SET UP menu.• Auto refreshing may be activated during theauto mode to calibrate the lens position.■ Flip-A-Chip SettingFLIP-A-CHIP is for setting the movement of the cameraby using the joystick.The factory default setting is OFF.OFF: Tilt range is limited to 0 ° to 92 °.ON: The flip-a-chip function allows the tilt angle towiden up to 180 °.Note: Flip-a-chip does not work if PAN LIMIT is set toON.■ Cleaning (CLEANING)CLEANING is used for refreshing the electro-mechani-cal contacts built into the camera. Use this function formaintenance when the camera has been directed at aspecific spot or panned over a specific range for a longtime.Built-in electric mechanical contacts are refreshed atregular intervals (approx. 7 days) if CLEANING is set toON.A dry contact adversely affects picture quality andmotor operation.The factory default setting is OFF.ON: The contacts are cleaned for approx. 1 minute."CLEANING" disappears when the process is com-pleted.OFF: No contact cleaningNote: Select OFF when the camera downloads oruploads preset data.■ Image Hold (IMAGE HOLD)The camera picture remains as a still image on themonitor screen until the camera reaches the presetposition. The factory default setting is OFF.2S 3S30S 10S20S5S** AUTO PAN **POSITION STARTENDSPEED ••••|••••L HPAN LIMIT OFFENDLESS OFFDWELL TIME 2SRET** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING OFFIMAGE HOLD OFFCAMERA ONETWORK O** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING ONIMAGE HOLD OFFCAMERA ONETWORK OCLEANING** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING OFFIMAGE HOLD ONCAMERA ONETWORK O