-21-Connection type Item Parameter descriptionHost name Contact your Internet service provider and enter the assigned hostname if required.Network speed Select the network speed by pressing the [o] button.Selectable parameters: auto (default setting), 100 Mbps (fullduplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps(half duplex)HTTP port If two or more cameras are connected, each camera needs to beset up individually.The port numbers already assigned to other hardware are notavailable.The following are already assigned to the camera.Port numbers: 20, 21, 23, 25, 53, 67, 68, 38, 80, 546, 547The following are not usable if the FTP client function is set to ON.Port numbers: from 4000 to 5000Do not use the same port number set for the Panasonic protocolwhen using the Panasonic Protocol function.Do not use the same port number set for NTP when using theNTP function.DHCP Click ON if the router uses DHCP.DNS Click ON when using the DNS server.Primary DNS 0, 0, 0, 0Secondary DNS Enter the IP address of DNS when using the DNS server.Contact your Internet service provider for the IP address of theDNS. Primary and secondary IP addresses can be set for theDNS.DDNS Click ON when using the DDNS function.Host name Ask your administratorUser name Ask your administratorPassword Ask your administratorAccess interval Ask your administratorPreliminary SetupPrior to connection to the system, you need to set up anetwork address for the camera by one-to-one connec-tion with a PC.The factory default parameters are as follows:IP address: 192.168.0.10Subnet mask: 255.255.255.0Gateway: 192.168.0.1HTTP port number: 80Network Cable (Cross type)1. Enter an IP address, "http://192.168.0.10" for exam-ple, in the address bar of the browser to displaythe main page of the WV-NS324 camera.2. Click the [Setup Menu] button. The authenticationdialog appears.