Panasonic WV-NS324 Operating Instructions Manual

Also see for WVNS324 - NETWRK CLR DOME CAME: Brochure Reference

Panasonic WV-NS324 Operating Instructions Manual Manual pdf 29 page image

-30-The following setting procedures are described on theassumption that this model is used in combination withthe WJ-SX550C Matrix Switcher and WV-CU550CJSystem Controller. In case a controller other than theWV-CU550CJ is used, refer to the table on page 29.■ Menu Display● Setup Menu DisplayWV-CU550CJ1. Select the camera number you want to set up anda monitor to display the SET UP MENU.2. Display the D4 menu on the LCD by pressing theappropriate cursor buttons.3. Press the [F1] button.SET UP MENU appears on the monitor screen.4. To close the SET UP MENU, press the [F4] button.WV-CU360CJPress the CAM SETUP key while holding down theSHIFT key to open the SETUP menu.WV-CU161CPress the CAMERA SETUP key for 2 seconds ormore to open the SETUP menu.WV-RM701. Turn the MODE SELECTION switch to NORMAL orALARM OFF.2. Press the PROG switch for 2 seconds or more toopen the Program Menu.3. Move the cursor to Camera Set Up Menu, andpress the SET switch to open the SETUP MENU.● Submenu DisplayThe items marked O can be selected/changed on thesubmenu.• Move the cursor to an item with the O mark andpress the CAM (SET) key. The submenu appears.■ Presetting● Preset Menu Display1. Displaying the preset menu directly(1) Move the cursor to PRESET 1 O and selectthe position number by moving the joystick tothe right or left.(2) Press the CAM (SET) key.The preset setting menu appears on the moni-tor screen.2. Displaying the preset menu from the PRESETNUMBER SET menu(1) Move the cursor to MAP O and press theCAM (SET) key.The PRESET NUMBER SET menu appears onthe monitor screen.(2) Move the cursor to the position number to beset and press the CAM (SET) key.The preset setting menu appears on the moni-tor screen.Notes:• The * mark indicates that the position numberhas been preset.• The character H refers to the home position.• On the second bottom line, the preset IDappears respective to the selected number."DOOR" next to "ID" in the example shown rightis for preset position number 1.SETTING PROCEDURESF1F1 F2 F3 F4Camera Set Up MenuRes A.Res ExitF2 F3 F4Camera Set Up MenuOn Exit** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING OFFIMAGE HOLD OFFCAMERA ONETWORK O** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING OFFIMAGE HOLD OFFCAMERA ONETWORK O** SET UP MENU **PRESET 1 OMAP OHOME POSITION OFFSELF RETURN OFFAUTO MODE OFFFLIP-A-CHIP OFFCLEANING OFFIMAGE HOLD OFFCAMERA ONETWORK O