Panasonic WV-NS324 Operating Instructions Manual

Also see for WVNS324 - NETWRK CLR DOME CAME: Brochure Reference

Panasonic WV-NS324 Operating Instructions Manual Manual pdf 46 page image

-47-Note: Input an external alarm signal of more than100 ms.3. Alarm PresetSelect the item by pressing the [o] button, andclick the [SET] button.1POSI: Camera performs according to Preset posi-tion 1 when there is input at ALARM IN 1.2POSI: Camera performs according to Preset posi-tion 2 when there is input at ALARM IN 2.OFF: No alarm preset used. Set Preset position 1and 2 in advance when using this function.The default setting is OFF.4. E-mail Notice SetupE-mail Notice: In ON position, an e-mail is sentwhen alarm arises. The default is OFF.E-mail Server Address: Input the Mail ServerAddress in not more than 128 numbers orsmall letters of one byte. When using DNS,input "host name. Domain name".Sender E-mail Address: Input the Sender E-mailAddress. The default is NW_Camera.It is named "NW_Camera@(IP address of cam-era)" when input without the @ mark.• Select ON or OFF for Attach Image.ON: Attaches the alarmed picture to the e-mail.OFF: No picture attached. The default settingis OFF.• Click the [SET & REBOOT] button.• Enter up to 4 destination e-mail addresses,and click the [SET] button.• Click the [DEL (delete)] button after selectingan unwanted e-mail address to delete it.Notes:• The e-mail address of the sender is one andthe same as that of the administrator.• Sending mails is not possible in an environ-ment that requires authentication for SMPTE orPOP3.5. Recording SetupThe image fields before and after an alarm inputare stored in the memories of the cameras.• Set the number of image frames for prerecording (0 - 20) and post recording (1 - 20).• Set the recording rate (fps: frame per second).Pre-recording rates: 1/10, 1/5, 1/3, 1/2, 1, 2,3.3, 5 ..... The default setting is 1.Post-recording rates: 1/10, 1/5, 1/3, 1/2, 1, 2,3.3, 5, 10 ..... The default setting is 1.• Click the [SET & REBOOT] button.6. Panasonic Protocol Setup• Select ON or OFF.ON: Sends alarm notice mails to the cus-tomized destinations.OFF: Does not send.• Enter the destination port. The port numberis exclusively assigned to this function, andany other usage is not allowed.• Enter a number of retries from 1 to 25.• Click the [SET] button.• Enter a maximum of 8 destination IPaddresses, and click the [SET] button.• Click the [DEL (delete)] button after select-ing an unwanted destination to cancel it.Destination IP AddressInput the Panasonic Protocol Destination IPAddress, and click the [SET] button.7. External Terminal Output SetupAlarm output is supplied from the Alarm OUT con-nector when Terminal 1, Terminal 2 or VMD is inuse.• Select a signal type :Pulse: Holds active status during the specifiedtime width.Latch: Holds active status until reset manually.• Enter the pulse width (necessary number x100 ms) if you selected Pulse. A number from1 to 100 is applicable.• Click the [SET & REBOOT] button.8. External Alarm Reset• Click the [Alarm Reset] button to cancel theactivated alarm.Note: Wait around 5 seconds or more when exe-cuting [SET&REBOOT] button.■ FTP Client SetupImage files can be transferred to the FTP server withinthe scheduled time zone.