Note: All DIP switches except SW1 and SW2 shouldalways be set to "off".3. Assemble the CameraReverse the disassembly procedure. Take care notto cut any cables.PrecautionBe sure to select a ceiling board strong enough to sup-port 4 times the total weight of the camera.a. Sideway Cable ExitPrepare a cutout in the diecast case and decora-tion cover as shown in the following figures.Cutout in Diecast CaseStatusNo.-9-INSTALLATIONPrecautions• The following installation and connection workshould be done by qualified service personnel orsystem installers and should conform to all localcodes.• Be sure to switch the camera off before installationand connection.• Do not install the camera near the air outlet of anair conditioner.1. Disassembling the Camera(1) Loosen the fixing screw to separate the cam-era mounting base from the camera. Push upthe screwdriver once before removing thescrew.(2) Turn the camera mounting base approximately15 degrees counterclockwise and remove thebase from the camera.2. Setting SwitchesThe camera is provided with an 8-bit DIP switch.The 8-bit DIP switch is used to return the camera tothe factory default settings. Switch settings areread into the camera when the power is turned on.Make sure to turn the camera off, then turn it backon after changing the switch settings. Switch posi-tions and functions are shown below.Note: When taking these procedures, keep thepower turned on until initialization of theCamera Servo Control is completed.Camera mounting baseCameraCamera mountingbaseFixing screwLoosen andpush15°Turn 15°ThenCameramounting baseRemovefrom thecameraDip SWPositionDIPSW1DIPSW21 OFF OFF Normal 1 2 3 4ON5 6 7 88-bit DIP SWNormal Position1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 82 ON OFF Initializing the setup menu3 OFF ON Initializing HTML files4 ON ON Initializing the setup menu& HTML files1 2 3 4ON5 6 7 88-bit DIP SW