-19-■ Network Setup Parameters vs. Connection TypeConnection type Item Parameter descriptionConnection type 1 IP address Enter "192.168.0.XXX" (where XXX should be a number from 2 to254 except the same IP addresses already assigned to the PC orany other cameras).Net mask Use the default setting "255.255.255.0" for the subnet mask.Default gateway 192.168.0.1Host name NW_CameraNetwork speed Select the network speed by pressing the [o] button.Selectable parameters: Auto (default setting), 100 Mbps (fullduplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps(half duplex)HTTP port Use the default setting "80" for the HTTP port.DHCP Click OFF.DNS Click OFF.Primary DNS 0, 0, 0, 0Secondary DNS 0, 0, 0, 0DDNS Click OFF.Host name NoneUser name NonePassword NoneAccess interval NoneConnection type 2 IP address Enter the IP address assigned by your network administrator.The setting is not required if DHCP is used in an intranet.Net mask Enter the Net mask assigned by your network administrator.The setting is not required if DHCP is used in an intranet.Default gateway Enter the IP address of the default gateway assigned by your net-work administrator.The setting is not required if DHCP is used in an intranet.Host name Contact your network administrator and enter the assigned hostname if required.Network speed Select the network speed by pressing the [o] button.Selectable parameters: Auto (default setting), 100 Mbps (fullduplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps(half duplex)HTTP port Use the default setting "80" for the HTTP port.DHCP Click ON if the intranet uses DHCP.DNS Click ON when using the DNS server.Primary DNS 0, 0, 0, 0Secondary DNS Enter the IP address of DNS when using the DNS server.Contact your Internet service provider for the IP address of DNS.Primary and secondary IP addresses can be set for the DNS.DDNS Click ON when using DDNS function.Host name Ask your administratorUser name Ask your administratorPassword Ask your administratorAccess interval Ask your administrator