D7 REMOTE CALL FORWARDING SETInstallation Manual 381D7 REMOTE CALL FORWARDING SETThe Message Manager can program his extension (assigned for Operator 1 in the Day Mode)from a remote location to forward various types of calls to a desired extension or an outsidetelephone. There are six forwarding settings available:• FWD All—Forward all incoming calls to a desired extension number.• FWD Busy—Forward all incoming calls to a desired extension number when the line isbusy.• FWD No Answer—Forward all incoming calls to a desired extension number when thereis no answer.• FWD Busy or No Answer—Forward all incoming calls to a desired extension numberwhen the line is busy or there is no answer.• FWD to CO—Forward all incoming calls to Telephone number 1 or 2 (preprogrammed inthe Mailbox Setting), or to any other telephone number.• FWD Cancel—Cancel the forwarding setting.Notes• The Remote Call Forwarding Set feature is available with DPT Integration only.• By default, the extension number for the Message Manager’s extension (assigned forOperator 1 in the Day Mode) is "0". However, the default setting cannot be used withthis feature. When using this feature, you must assign the extension number that isincluded in the Extension Numbering Plan.• FWD to CO must be enabled in the COS (Class of Service) setting to be utilized (see"Remote Call FWD to CO" in Table B-7 in B3 SYSTEM ADMINISTRATION—SETTING COS (CLASS OF SERVICE) PARAMETERS).• FWD to CO must also be enabled in the COS setting in the PBX for each extension.Assigning Remote Call Forwarding Set1. Log in the Main Menu.2. Press [6] to set Remote Call Forwarding.3. Press [1], [2], [3], [4], [5], or [6] to select the desired forwarding setting.• [1] FWD All• [2] FWD Busy• [3] FWD No Answer• [4] FWD Busy or No Answer• [5] FWD to CO
