3.3 CONNECTING THE VPS WITH PANASONIC KX-T SERIES PBXsInstallation Manual 55Flexible Ringing Assignment—For each outside (CO) line, use SystemPrograms [47] (Day Mode) and [48] (Night Mode) to enable ringing on everyextension (jack) that you want to have ring.Delayed Ringing Assignment—To give users time to answer the call before theVPS picks up, we recommend setting the delay to 3 or 4 rings for each extensionconnected to the VPS. Use System Programs [49] (Day Mode) and [50] (NightMode).CO Mode—Set the mode for each outside (CO) line to "Normal". Use SystemPrograms [51] and [52] to set this parameter.3.3.3 KX-TA624 Programming for Inband Integration via theManager’s ExtensionNoteIf your PBX is the KX-TA1232, please refer to the procedure described in 3.3.5 KX-TD816, KX-TD1232, KX-TA1232 and KX-TD308 Programming for Inband Integration viathe Manager’s Extension or 3.3.6 KX-TD816, KX-TD1232, and KX-TA1232 Programmingfor Inband Integration via the Operating and Maintenance Tool for programming.1. Enable System Program [102] for each extension connected to the VPS. Jack 07, or jacks07 and 08 can be assigned for the VPS as the Voice Mail port. Jack 15, or jacks 15 and16 can be assigned for the VPS2.This parameter is used to tell the KX-TA624 which extensions are connected to the VPS.Ports with this parameter enabled can receive Follow-on ID and touchtone call statusSignaling (busy, answered, disconnect, etc.) if the DTMF Integration features are alsoenabled in System Program [103].2. Enable System Program [103] to turn on DTMF Integration. On extensions with the VoiceMail port parameter enabled, the KX-TA624 can send codes (touchtones) to indicate callstates; this increases VPS efficiency. Codes apply to all transferred calls; outside callsonly indicate disconnect (provided the KX-TA624 is programmed for CPC Detection, andthe Central Office sends the CPC signal). Refer to the Table 3-3 SEQUENCE CODES inSection 3.2.4 PBX Interface Parameters.3. Put all extensions connected to the VPS into 1 extension group using System Program[600].Reserve this extension group for these extensions! Do not mix other extensionsinto this group.NoteUp to two VPS units can be connected to the KX-TA624. When two VPS units areconnected to the KX-TA624, 2 different extension groups should be assigned for eachVPS in System Program [600]. One extension group is for jack 07, or jacks 07 and 08 ofthe KX-TA624. The other extension group is for jack 15, or jacks 15 and 16.4. Enable hunting for the VPS extension groups using System Program [100].
